Mazda B-Series 1997 Workshop Manual page 81

B1
ON-VEHICLE MAINTENANCE
Removal Note
Rear oil seal
1. Cut the oil seal lip with a razor knife.
2. Remove the oil seal by using
a
screwdriver protected with
a rag.
4BUOB1-054
Installation Note
Rear oil seal
lnstall the rear oil seal using the SST.
Caution
The rear face of the oil seal must be within 0.508mm
(0.019 in) of the rear face of the cylinder block.
Note
Applya small amount of clean engine oil on the new
oil seal and the seal mating surface.
lnstall the new oil seal with the spring side toward
L
1
MBI 038-c ~BUOBI-033
the engine.
I
I
Drive plate (AT)
1. lnstall the drive plate.
2. Install the reinforcement plate and bolts.
Tightening torque:
73-47 N.m (7.4-4.8 kgfsm, 54--64 ft.lbf)
L
1
MB1203-B 5BUOB1-034
Flywheel (MT)
Install the flywheel and bolts.
Tightening torque:
7 3 - 8 7 N-m (7.4-4.8 kgfem, 54--64 ft-lbf)
Steps After Installation
1.
Connect the negative battery cable.
2. Start the engine and check for leaks.