Omron FQ2-S4 User Manual page 8

5. Handling
• Connector Cover
Always attach the connector cover when you disconnect the cable. If you do not attach the connector cover,
foreign matter may enter the connection, causing malfunctions or damage.
• Lens Cap
Always attach a C-mount lens cap to the lens mount when you remove the lens. If dust or dirt adhere to the
imaging elements, false detection or failure may occur.
• Sensor Waterproof Sheets
Do not remove or damage the waterproof sheets on the sides of the Sensor. Doing so may allow dust, dirt,
or water drops to enter the Sensor and damage it.
6. Other
• Do not use this product in safety circuits associated with nuclear power and human life.
• Do not disassemble, repair, modify, deform by pressure, or incinerate this product.
• Dispose of this product as industrial waste.
• Connect the special products (Sensor, Touch Finder, Cables). The product might break down or malfunction
if you use a part not included in the special products.
• If you notice an abnormal condition, such as a strange odor, extreme heating of any product, or smoke,
immediately stop using the product, turn OFF the power, and consult your dealer.
• The Sensor surfaces become hot during use. Do not touch them.
• Do not drop or subject the products to shock.
• Use the special Sensor (FQ2-S4), Touch Finder (FQ2-D), Sensor Data Unit (FQ-SDU), Cables (FQ-WN,
FQ-WD, FQ-WU, and FQ-VP), Battery (FQ-BAT1), and AC Adapter (FQ-AC). Using other than the specified
products may cause fire, burning, malfunction or failure.
• If the product has a lock mechanism, always make sure it is locked before using the product.
7. Laws and Regulations, Standards
• This product complies with the following EC Directives and EN Standards:
EC Directive No. IEC61010-1
EN Standards EN61326-1: 2006
6
FQ2-S4 User's Manual