Table of Contents
Advertisement
Step 2
Teaching
Teaching means to store the region and the average color in the region as reference data for the measurement.
− [Inspection]
[Inspect]
1
Press [Teach].
2
Place the object that is to be used as the measure-
ment reference in front of the camera.
3
Move the rectangle to the location to be measured.
4
Press [OK].
5
Press [TEACH] on the lower right of the display.
The basic settings will be registered when teaching has
been completed.
6
Press [Back] to end teaching.
Changing the measurement region: p. 144
The following data is stored as the measurement reference.
Item
Parameter
Reference data
Hue
Saturation
Brightness
Step 3
Adjusting Judgement Parameters
− [Inspection]
[Inspect]
1
Press [Judgement].
2
Press the parameters and set the range that is to be
judged as OK.
The measured value is displayed beside the parameter
name. Continuous measurements will be performed for
the images that are displayed.
Note
You can change the parameters for judgement conditions on the
Display Settings Display. Press [
of the display to switch to the Display Settings Display.
3
Press [OK] to enter the value.
FQ2-S4 User's Manual
− [Add item.] − [Color Data] − [Settings] Tab Page
Description
The hue to use as a reference is set automatically.
The saturation to use as a reference is set automatically.
The brightness to use as a reference is set automatically.
− [Add item.] − [Color Data] − [Settings] Tab Page
− [Display setting] on the right
]
Drag the rectangle to move it.
Drag a corner to size the rectangle.
Lower limit
Upper limit
Blue for OK. Red for NG.
Inspecting with Color Data Inspection Item
179
Advertisement
Table of Contents
Troubleshooting
