Errors - Omron FQ2-S4 User Manual

Measurement Data That Can Be Logged
The following values can be logged as measurement data.
Parameter Range of value
−2: No judgement (not measured),
Judgement
0: Judgement is OK,
−1: Judgement is NG,
−13: Teaching not performed error,
−14: Figure not registered error,
−15: Out of range error
Correlation 0 to 100
D deviation 0 to 221
−99,999.9999 to 99,999.9999
Position X
−99,999.9999 to 99,999.9999
Position Y
−180 to 180
Angle
NG sub-region 0 to 100
Sub-region number 0 to 99
Sub-region pos. X (sub- 0 to 9
region number (X))
Sub-region pos. Y (sub- 0 to 9
region number (Y))
−999,999,999.9999 to
Sub-region position X
999,999,999.9999
−999,999,999.9999 to
Sub-region position Y
999,999,999.9999
Correlation (sub-region) 0 to 100
Deviation (sub-region) 0 to 221
* When logging data is output, the data is output in the order of the above table.
7-6 Logging Measurement Data and Image Data: p. 252

Errors

Errors in Teaching
A teaching error message will appear if the contrast of the image within the model registration region is too low.
Select a region with a larger contrast between light and dark areas compared to the region that was registered
as the model and re-register it as the model.
FQ2-S4 User's Manual
Description
This is the judgement result of the sensitive search.
Correlation
Density deviation
This is the X coordinate of the position where the model was found.
This is the Y coordinate of the position where the model was found.
This is the angle of the position where the model was found.
This is the number of NG sub-regions.
This is the number of the regions with the lowest correlation.
This is the column number in the X direction of the output region.
This is the row number in the Y direction of the output region.
This is the X coordinate of the sub-region that was found.
This is the Y coordinate of the sub-region that was found.
Correlation
Density deviation
Inspecting with the Sensitive Search Inspection Item
161