Omron FQ2-S4 User Manual page 125

[Item ref.]: Select this item to use the immediately pre-
ceding read results as the verification charac-
ter string. The following inspection items can
be used as references: Bar code, 2D-code,
2D-code (DPM), and OCR. You cannot refer-
ence an inspection item at an item number
that is after the item number of the inspection
item that you are editing. When you register a
character string from the master data, the
item number of the inspection item that is be-
ing referenced, such as "Ref. 00," will be dis-
played.
Using Item References: p. 101
5
Repeat the above procedure to register more than
one character string in the master data.
6
Press [Verif. master data] and select the character
string in the master data to use for verification.
7
Set the following verification conditions as required.
Setup Item Setting Value
Verif. master data OFF (default value)
All master data
Master data 0 to 31
Partial verif. on/off No (default value)
Yes
Partialo verif. setup 1 to 1024 (default value
first digit:1 last digit:1024)
Master data regist. ---
Auto teach No. OFF (default)
Master data 0 to 31
8
Press [Back].
FQ2-S4 User's Manual
Description
Sets whether to verify the character string that was read from the bar-
code against a character string that is registered in the master data. To
verify the read character string against the master data, select the char-
acter string to use for verification.
The number of digits in the read results to be verified with the master
data can be limited. When [Partial verification] is set to ON, set the first
and last compared digit positions. Up to 32 characters can be set as the
number of digits.
Example: First compared digit 2, last compared digit 6
O M R O N 2 0 0 8
6th digit
2nd digit
The text string used for verification becomes "MRON2".
Registers a character string in the master data.
Sets the character string in which to automatically register the read
result for teaching from an external device.
123
Reading 2D-codes