Table of Contents
Advertisement
Setting the Output Format
[In/Out] − [I/O setting] − [Output data setting] − [Link data output]
1
Press [Output format].
2
Press [Output form].
3
Set either a floating point decimal or a fixed decimal for the output form.
Item
Output form
Outputting Character Strings
You can set whether to output the character string that results from reading. Outputting the character string is
possible for the following inspection results.
• OCR
• Bar code
• 2D-code
• 2D-code (DPM)
The procedure for outputting the character string is given here for two inspection items.
[In/Out] − [I/O setting] − [Output data set] − [Link data output] − [Output data set]
1
Select the inspection item for which to output the character string.
2
Set the following items on the setting display.
Parameter
String output ON/OFF
Partial output ON/OFF
Output string setup
NG String output on/off
346
Outputting Data and Controlling Operation through EtherNet/IP
Description
Set the output form for numerical data.
Setting
OFF (default)
Yes
No (default)
Yes
1 to 128 for OCR
1 to 1024 for Bar code, 2D-
code, or 2D-code (DPM)
Yes (default)
No
Setting range
Floating point or fixed point (default: Floating
point)
Description
Sets whether to output the character string that results
from reading.
Sets whether to specify the range of characters to output.
Sets the output range.
Sets whether to output an NG string.
FQ2-S4 User's Manual
Advertisement
Table of Contents
Troubleshooting
