Setting Up No-Protocol Communications - Omron FQ2-S4 User Manual

Setting Up No-protocol Communications

Setting Network Settings in the Sensor
This section describes how to set the IP address and other network settings in the Vision Sensor. Refer to the
following section for details.
2-5 Setting Up Ethernet: p. 53
Initial Settings for No-protocol Communications
To perform no-protocol communications with RS-232C, you must set the communications baud rate, data
length, and other RS-232C communications parameters.
[Sensor settings] − [Data output] − [No-protocol data]
1
Press [Communication type] − [No protocol (RS-232C)].
2
Set the RS-232C communications parameters.
Note
If you connect to an OMRON PLC, set the PLC to Host Link
communications.
Item
Baud rate [bps]
Data length [bits]
Parity
Stop bit
Flow control
Delimiter
Interval timeout
Total timeout
448
Controlling Operation and Outputting Data with RS-232C No-protocol Communications
Description
Set the baud rate to use for RS-232C communications.
Set the same baud rate as the external device that you will communi-
cate with.
Set the same data length as the external device that you will communi-
cate with.
Sets the parity. Set the same setting as the one in the PLC communica-
tions specifications.
Set the number of stop bits. Set the same value as the one in the PLC
communications specifications.
Controls the flow of communications with the software.
Set the delimiter to add to the end of commands and responses.
Set the same delimiter as the external device that you will communicate
with.
Set the time in seconds to generate a timeout error.
Set the time in seconds to generate a timeout error.
Parameter
2400, 4800, 9600, 19200,
38400, 57600, or 115200
(default: 38400)
7 bits or 8 bits
(default: 8 bits)
None, Odd, or Even (default:
none)
1 bit or 2 bits (default: 1 bit)
None or Xon/Xoff (default:
none)
CR, LF, or CR+LF (default:
CR)
1 to 120 s, 0: Not monitored.
(default: 0 s)
1 to 120 s, 0: Not monitored.
(default: 0 s)
FQ2-S4 User's Manual