Omron FQ2-S4 User Manual page 301

Save Data in Sensor
You can save the current settings (scene data and system data) in the Sensor.
Note
This function can be used in Run Mode only.
Settings
[In/Out] − [I/O setting] − [I/O setting] − [Input] − [Input mode]
Press [Expand mode].
Wiring
Color Signal
Gray IN0
Green IN1
Red IN2
White IN3
Purple IN4
Yellow IN5
Orange OUT1 (BUSY)
Timing Chart
IN0 to IN4
signals
ON
IN5 signal
OFF
ON
BUSY
signal OFF
FQ2-S4 User's Manual Controlling Operation and Outputting Data with the Sensor's Standard Parallel Connection
State Description
ON Command parameters for saving data to
the Sensor
OFF
OFF
OFF
OFF
ON Command input for saving data to the
Sensor
-- Processing in progress (default)
Allow 5 ms min. and then
turn ON IN5.
ON for 1 ms min.
Saving data in
Saving data
Sensor completed.
in Sensor started.
The signals shown at the left
are used.
Refer to the following
information for signal wiring.
2-4 Wiring: p. 42
1 Turn ON IN0 and turn OFF IN1 to IN4.
2 Turn ON the IN5 signal while the
BUSY signal is OFF to save the data
in the Sensor.
299