Omron FQ2-S4 User Manual page 104

Note
You can set the [Item ref.] verification condition to check to see whether characters that are printed near a barcode or
2D code match the contents of the barcode or 2D code. Place the inspection item to read the barcode or 2D code to
check before the OCR inspection item and then specify the [Item ref.] verification condition for the OCR inspection
item. The verification condition will be used to verify whether the character string from the barcode or 2D code and
the characters printed below it match. You can output the verification result.
Read result: 0112345678901231 (Read with the [0.Bar code] inspection item.)
Barcode
Printed characters
5
Repeat the above procedure to register more than
one character string in the master data.
6
Press [Verif. master data] and select the character
string in the master data to use for verification.
Note
You can automatically register the read result from teaching from
an external device in the character string with number that is
specified [Auto teach No.] in the master data.
7
Press [Back].
Parameter
Verif. master data
Master data regist.
Auto teach No.
102
Reading and Verifying Character Strings
Read with [1.OCR] inspection item.
The verification condition is set to [0.Bar code].
Setting
OFF (default) Sets whether to verify the read character string against a character string that
All master data is registered in the master data.
Master data 0 to 31 To verify the read character string against the master data, select the character
string to use for verification.
--- Registers a character string in the master data.
OFF (default) Sets the character string in which to automatically register the read result for
Master data 0 to 31 teaching from an external device.
Barcode character string: 0112345678901231
Reference data setting: Item 0
Verification range for line 1: 1 to 16 (0112345678901231)
Description
FQ2-S4 User's Manual