Omron FQ2-S4 User Manual page 352

Signal
RUN
GATE
Command code
Response code
Response data
Important
If measurements are executed in parallel, the EtherNet/IP BUSY signal will also turn ON.
350
Outputting Data and Controlling Operation through EtherNet/IP
Signal name Function
Run Mode This signal is ON while the Vision Sensor is in Run Mode. Sensor status
This signal is OFF while the Vision Sensor is not in Run
Mode.
Data Output Com- This signal turns ON when the Vision Sensor finishes out-
pleted putting data.
If [Handshake setting] is set to [Yes], this signal automati-
cally turns OFF when the Data Output Request Bit (DSA)
signal from the PLC turns OFF. If [Handshake setting] is
set to [No], this signal turns OFF after the data output
period has elapsed.
Command code This I/O port returns the command code that was exe-
cuted.
Response code This I/O port contains the response code of the executed
command.
Response data This I/O port contains the response data of the executed
command.
Application
method
change output
Data output
after measure-
ments
Command/
response com-
munications
FQ2-S4 User's Manual