Omron FQ2-S4 User Manual page 168

Undesired Edge Position Is Automatically Detected When Teaching (Sensors with Color Cameras Only)
Manually set the color of the edge that you want to detect.
− [Inspection] −
[Inspect]
1
Press [ ] – [Color ON/OFF] on the right side of the display.
2
Press [ON].
3
] − [Set color.] on the right of the display.
Press [
4
] − [Detection mode] on the right of the dis-
Press [
play and select one of the following detection modes.
5
Draw a rectangle around the color that you want to
use to extract an edge.
The specified color will be extracted.
6
Press [OK] to enter the edge color.
7
Press [TEACH] again.
8
Press [Back].
Item
Detection mode
Beginning
position
Color IN
Note
It is also possible to check the extraction colors or specify them using the color palette.
The RGB values of the extraction color can be checked and adjusted using the color palette.
] − [Color palette], a color palette will appear.
If you press [
166
Inspecting with the Edge Position Inspection Item
[Edge Position] − [Modify]
Parameter Description
Color IN Detects as an edge any position where the color changes from another color
to the specified color.
Color OUT Detects as an edge any position where the color changes from the specified
color to another color.
Beginning
Ending
position
position
Color OUT
When a color is pressed on
the color palette, its RGB
values will be displayed.
− −
[Settings] Tab Page
(Only a rectangle can be used to specify the region.)
Ending
position
[Teach]
FQ2-S4 User's Manual