Measurement Data That Can Be Logged (Color Data); Increasing Processing Speed For Color Data - Omron FQ2-S4 User Manual

Measurement Data That Can Be Logged (Color Data)

The following values can be logged as measurement data.
Measured item Range of value
0: Judgement is OK,
Judgement
−1: Judgement is NG,
−13: Teaching not performed error,
−14: Figure not registered error,
−15: Out of range error
R average 0 to 255
G average 0 to 255
B average 0 to 255
Color diff./dens. AV. 0 to 442
Color (for Sensors
with Color Cameras)
Color diff./dens. AV. 0 to 255
Color (for Sensors
with Monochrome
Cameras)
Clr. deviat. (for Sen- 0 to 221
sors with Color Cam-
eras)
Clr. deviat. (for Sen- 0 to 127
sors with Mono-
chrome Cameras)
* When logging data is output, the data is output in the order of the above table.
7-6 Logging Measurement Data and Image Data: p. 252

Increasing Processing Speed for Color Data

Make the measurement region smaller to reduce the processing time.
Changing the measurement region: p. 144
FQ2-S4 User's Manual
Description
This is the measurement judgement results.
This is the average value for the R (red) component.
This is the average value for the G (green) component.
This is the average value for the B (blue) component.
This is the difference between the color that was registered
as the reference and the measured color. The average color
within the measurement area is used in both cases.
This is the difference between the average density in the
region and the currently measured density.
This is the deviation within the measurement region.
This is the deviation in the average density in the measure-
ment region.
Inspecting with Color Data Inspection Item
181