Omron FQ2-S4 User Manual page 409

• When Output Format Is ASCII
Set the parameters for integer digits, decimal digits, negative numbers, 0 suppression, the field separator,
and the record separator.
• Output Format
Measured value of
,
data 0
Note
The data output method, digits, and data separators can be changed as needed.
Example: Integer digits: 5, decimal digits: 3, negative number expression: −, zero suppressed: none, field
separator: comma, record separator: CR
1 2 3 4 5 . 6 7 8 ,
Measured value of data 0
Field separator
*1 Because the record separator is set to CR, only one record is output for each measurement. A blank line (CR:
delimiter) will therefore be entered after the record separator. If you do not want a blank line, set the record sepa-
rator to None.
Note
The field separator is not output unless the data continues.
The following range of values can be output.
−999,999,999.9999 ≤ Measured value ≤ 999,999,999.9999
If the measured value is lower than −999,999,999.9999, then −999,999,999.9999 is output.
If the measured value is higher than 999,999,999.9999, then 999,999,999.9999 is output.
The following values are output if JG (Judge) is set.
OK: 0
NG: −1
Note
Data that is output after measurement is output until the last data even after the measurement is finished. Data out-
put is not interrupted midway.
• When Output Format Is Binary
Set the numerical expression.
Select either fixed decimal or floating-point decimal.
• Output Format
<Measured value of data 0 × 1,000><Measured value of data 1 × 1,000>
4 bytes
The measurement data multiplied by 1,000 is output continuously at 4 bytes per data. Negative numbers are
output as two's complements.
FQ2-S4 User's Manual Controlling Operation and Outputting Data with TCP No-protocol Communications
Measured value of
,
data 1
5 6 7 . 3 2 1 ,
Measured value
of data 1 value of data 2
Field separator
4 bytes
Measured value of
· · ·
data 7
7 6 . 9 2 1 , ,
Measured Field separator
Field separator
<Measured value of data 7 × 1,000>
· · ·
4 bytes
CR
6 5 9 8 7 . 1 6 5 CR CR
Measured
Delimiter
value of data 7
Record separator
CR
Delimiter
*1
407