Dtc P1685: Can Communication (Reception Error For Abs Control Module) - Suzuki Grand Vitara Service Manual

DTC P1685: CAN Communication (Reception Error for ABS Control Module)

Wiring Diagram
Refer to "DTC P1674: CAN Communication (Bus Off Error): ".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Reception error of communication data for ABS hydraulic
unit / control module assembly is detected for longer than
specified time continuously.
(1 driving detection logic)
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch turned OFF.
2) Turn ON ignition switch and clear DTC by using scan tool.
3) Start engine and run it for 1 min. or more.
4) Check DTC.
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions For DTC Troubleshooting: ".
Step
1 Was "Engine and Emission Control System Check"
performed?
2 DTC check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Check ECM, TCM (for A/T model), ABS hydraulic unit /
control module assembly, 4WD control module (for J20
engine), keyless start control module (if equipped) and
BCM for DTC.
Is there any DTC(s) other than CAN communication DTC(s)
at each control module (other than DTC P1618, P1674,
P1676, P1678, P1685 in ECM, DTC P1774, P1777, P1778
in TCM (for A/T model), DTC U1073, U1100, U1101, U1121
in BCM, ABS hydraulic unit / control module assembly and
4WD control module (for J20 engine), and DTC No.31 / 33 in
keyless start control module (if equipped))?
3 Check CAN communication error for ECM
1) Check ECM for DTC.
Is there DTC P1674?
4 ECM and ABS hydraulic unit / control module connector
check
1) Check for proper connection at each ECM and ABS
hydraulic unit / control module connector terminals with
ignition switch turned OFF.
2) If connections are OK, recheck ECM for DTC with
engine running.
Is there DTC P1685?
www.CarGarage.ir
Action
www.CarGarage.ir
Engine General Information and Diagnosis:
Trouble area
• ECM
• ABS hydraulic unit / control module assembly
• CAN communication line circuit
Yes
Go to Step 2.
Go to applicable DTC
diag. flow.
Go to "DTC P1674:
CAN Communication
(Bus Off Error): ".
Go to Step 5.
1A-184
S5JB0A1104094
No
Go to "Engine and
Emission Control
System Check: ".
Go to Step 3.
Go to Step 4.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection: in Section
00".