Table of Contents
Advertisement
Hardware Manual
7. Loosely attach the rear slide assembly brackets with four #10-32 locknuts to the outer slide
members.
This makes it easier when attaching the brackets to the frame adapters or frames. See
49: Slide Assembly Outer Member
the factory.
Figure 49: Slide Assembly Outer Member
8. Attach the front and back slide assembly brackets on each slide assembly with four #12-24
Phillips screws to the four frame adapters installed in
Both slide assemblies are identical. Viewed from the rear of the frame, orient the slide assemblies
with the rear detent latches at the bottom on the left slide assembly and at the top on the right
slide assembly. See
Note: The inner slide members are shown inserted into the middle slide member in this view
for clarity only. In the following steps the inner slide members will be attached to the T1100AS
chassis and inserted into the middle slide members.
Figure 50: Slide Assembly Detail Left Side From Rear
910-2969-001 Revision K, June 2009
on page 75. The front slide assembly brackets are mounted at
Figure 50: Slide Assembly Detail Left Side From Rear
How to Install Hardware in an Existing Frame
Step 6
on page 73.
on page 75 for positioning.
Figure
75
Advertisement
Table of Contents
