How To Replace At1100 As Chassis Fru - Tekelec 1100 Hardware Manual

Field Replaceable Units
23. Do one of the following:
a) If this procedure is being performed to move PCI cards from a failedT1100 AS chassis to
the replacementT1100 AS chassis, skip to the next step.
b) If this procedure is being performed to replace a failed PCI card, do the following:
Attach the label that was received with the replacement PCI card on the appropriate
section of the PCI card label located on the left side of theT1100 AS chassis (for a diagram
of the label, see
theT1100 AS chassis, see
Return the failed PCI card to Tekelec, using the shipping contained in which the
replacement PCI card was received. Arrange the return shipment by using the procedures
described in
24. This procedure is complete.

How to Replace aT1100 AS Chassis FRU

Replacing aT1100 AS chassis requires that the slide assemblies be removed from the failed chassis
and attached to the replacement chassis. A replacement chassis always contains fan assemblies
and a removable media disk drive assembly. However, it does not contain replacement PCI cards
or hard disk drives unless those parts are specified to be replaced when the Return Material
Authorization (RMA) is obtained.
Usually, when aT1100 AS chassis needs to be replaced, the PCI cards and hard disk drive assemblies
are removed from the failedT1100 AS chassis and placed in the replacement chassis. It is
recommended that the slide assemblies be attached to the replacement chassis, using the procedure
in this section, before moving the PCI cards and hard disk drive assemblies.
Use the following procedure when the Customer Care Center has determined that theT1100 AS
chassis needs to be replaced.
1. Ensure that the following have been done:
a) An RMA has been obtained (see
about the part numbers to be supplied, see
.
b) A spare part is available
2. Inspect the unit and shipping container for indications of damage.
If damage is noted, contact the project manager or report damage to the carrier.
3. Inventory the material in the shipping container and notify the project manager or Tekelec
Production Control of any discrepancies.
WARNING: Observe proper ESD procedures when handling theT1100 AS chassis.
Always wear an ESD wrist strap connected to a grounded bench or frame.
4. Unpack theT1100 AS chassis from the shipping container and place the unit on a secure
workbench that is grounded for ESD protection.
Save the container and packing material for use in
5. Shut down the server.
134
Figure 81: PCI Slots Label
How to LocateT1100 AS Part Numbers
Hardware Repair and Return
Hardware Repair and Return
on page 130; for placement of this label on
on page 14 ).
on page 11
on page 11 ); for information
How to LocateT1100 AS Part Numbers
Step 10 on page 135.
910-2969-001 Revision K, June 2009
Hardware Manual
on page 14