Table of Contents
Advertisement
Figure 7-2. Chassis Retention Hardware
6.
From the front of the frame, using the handles on the front top cover or the
knurled screws on the sides of the chassis, pull the T1100 AS chassis forward
until the release buttons on the inner arms of the slide assemblies pop into the
holes on each side.
DANGER: Moving a T1100 AS chassis requires two people. Each T1100
AS chassis weighs approximately 30 kg (65 lbs) and may cause personnel
injury or damage to the internal components due to shock and vibration if
not handled properly.
7.
Simultaneously depress the chassis release buttons on each side and slowly
pull the chassis forward until the chassis and attached inner slide members
are completely free of the slide assemblies. See Figure 7-3 on page 7-17 for
locations of the release buttons.
8.
Place the chassis on a grounded bench and attach the ground wrist strap to
the bench.
9.
This procedure is complete.
7-14
Preliminary
910-2969-001 Revision H, February 2007
Field Replaceable Units
Advertisement
Table of Contents
