FRAME/BODY PANELS/EXHAUST SYSTEM
FRONT HANDLEBAR COVER
Remove the front upper cover (page 3-9).
Remove the following:
– rear view mirrors
– handlebar post lid (by sliding it forward)
– four tapping screws
Push the rear handlebar cover and release the four
tabs of the front handlebar cover.
Disconnect the headlight 3P (black) connector and
Be careful not to
remove the front handlebar cover.
scratch the front
inner cover.
Installation is in the reverse order of removal.
Route the head-
light wire properly
TORQUE:
(page 1-19).
Rear view mirror lock nut:
FRONT HANDLEBAR COVER
REAR HANDLEBAR COVER
Remove the front handlebar cover (page 3-14).
Remove the following:
– two tapping screws (front side)
– screw (rear side)
Remove the rear handlebar cover from the handle-
bar and disconnect the handlebar sub harness 12P
(Gray) and combination meter 16P connectors.
Installation is in the reverse order of removal.
Route the wires
properly (page 1-
19).
3-14
34 N·m (3.5 kgf·m, 25 lbf·ft)
REAR VIEW MIRRORS
POST LID
TABS
3P CONNECTOR
REAR HANDLEBAR COVER
TAPPING SCREWS
SCREWS
SCREW
CONNECTORS