Cr Motor Endurance Menu - MUTOH ValueJet Service Manual

5.13.1 CR Motor Endurance Menu

This menu performs endurance running for the CR motor.
You can operate the carriage stroke according to your desired settings. The available settings are shown
below.
Set item
Running speed (CW,
CCW)
Number of endurance
running cycles
CAUTION
When the CR motor endurance running is performed, note the following;
• Install available ink cartridges.
If the CR motor endurance running is performed without ink cartridges, ink inside the tube
may leak through the ink holder during the carriage movement.
TIP
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If the
number of cycles exceeds the maximum value, the counter is reset to 0.
• The carriage moving distance is fixed to the maximum value of print area.
AP-74109 Rev 1.1
Table 5-19 Set Items in CR Motor Endurance Menu
Contents
Set the carriage running speed
(CW direction, CCW direction)
Set the number of endurance
running cycles
[Enter] key
[Enter] key
[Enter] key
[Enter] or [Cancel] key
ValueJet 1304 Service manual
Set value
100, 120, 160, 200,
240, 320, 400
-1 to 10000
CW-speed
CCW-speed
Endurance Count
Performing endurance
5-68
Remark
Unit: cps