Cr Motor Endurance Menu - MUTOH Valuevet VJ-628X Maintenance Manual

5.11 Endurance Running Menu
5.11.1

CR Motor Endurance Menu

This menu is used to perform carriage stroke to perform the endurance running of CR motor.
The available settings are shown below.
Item Contents
Speed Set Carriage running speed (CW
(CW, CCW) direction, CCW direction).
Width Travel distance of Carriage
Life Count Set the number of endurance running
cycles.
CAUTION
When performing the CR motor endurance running, install Ink cartridges.
If the CR motor endurance running is performed without ink cartridges, ink inside the
tube may leak through the ink holder during Carriage movement.
NOTE
When a speed mode is "Low", the part of 400 is printed with 240.
• If the number of endurance running cycles is set to -1, Carriage continuously
repeats endurance running until it is canceled from Operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-
digit number). If the number of cycles exceeds the maximum value, the counter
displays 99999999.
5.11.1 CR Motor Endurance Menu
[Enter]/
[Cancel]
Values Remark
310, 320, 400, Unit:cps
420
400~757 mm
-1, -
1 to 10000
[Enter]
Change the value (unit to count)
by pressing [+] or [-] key.
[Enter]
CW-speed
[Enter]
CCW-speed
[Enter]
travel distance
400mm~757mm
[Enter]
Endurance Count
[Enter]
Performing endurance
Completing Endurance or [Cancel]
VJ628XE-M-00
331