Honda VT750C2 Shadow Spirit Service Manual page 192

CYUNDER HEAD/VALVE
REAR CYLINDER TDC SETIING
If the front cylinder
Remove the front cylinder head cover (page 9-6)
INDEX NOTCH
has not been
and check the front cylinder camshaft position as
serviced, begin
follows:
here.
Turn the crankshaft counterclockwise and align the
"FT" mark on the flywheel with the index notch on
the left crankcase cover, then check the identifica ­
tion mark "F" on the front camshaft.
- If the "F"mark faces up, turn the crankshaft coun­
tercJocl<vvis~Jo§at308°)
turn (align the "RT" mark
on the flYWh~rl W}ththe index notch) and begin
installation ofthe rear camshaft.
Ifthe""F" marKJ~cElSd.6\IV11 (cannot be seen), turn
otHe cranksh~ft·d02kWjse
l-Sn (668°) turn (align
the "RT" mark with the index notch) and begin
installation of the rear camshaft.
Install the· reatcan1shaftlJsing the following proce ­
"F" MARK
dure.
CAMSHAFTINSTA~.t-A
TION
NOTE:
0 •• 0 ..• 00 ••.•• 0
MakesuretofoHoWot~e~~l\t1SHAFT TIMING PRO ­
.
CE~b'REJJ)age~~27f bE3t~m'installing
the camshaft.
The frontand rear
LUbri~ate;lhe,,~~°rJISJ1aftJOb~sand
journal surfaces ...- - - ­
camshafts are
V\'.\thiiloJY~~~~(jm disulfipe~oir.
installed with the
.Jpstall the camshaftwith 1h8ccamshaft identification
same procedure.
mark (R: rear cams;haft, F:fr,qnt camshaft) facing up.
9-29