Isuzu 1999 RODEO Workshop Manual page 83

f Be sure to apply new compressor oil to the O-rings
when connecting the refrigerant line.
3. Connect pressure switch connector.
Condenser Fan Motor and Associated Parts
Legend
(1) Condenser Fan Assembly
(2) Condenser Fan Motor
Removal
1. Disconnect the battery ground cable.
2. Discharge and recover refrigerant.
f Refer to Refrigerant Recovery in this section.
3. Remove radiator grille.
4. Remove condenser fan assembly.
f Disconnect the fan motor connector and remove
the 4 fixing bolts.
5. Remove shroud.
f Remove the 3 fixing nuts.
f Loosen the condenser fixing nut and disconnect the
fan motor connector from bracket.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–55
4. Install engine hood lock.
5. Install engine hood front end stay.
6. Install radiator grille.
Condenser Fan Motor
(3) Radiator Grille
(4) Shroud
(5) Fan
6. Remove fan.
7. Remove condenser fan motor.
Installation
To install, follow the removal steps in the reverse order,
noting the following point.
1. Route the fan motor harness in its previous position,
f Remove the fan fixing C-ring and plate.
and fix it securely with clip and bracket.
875RW009