Isuzu 1999 RODEO Workshop Manual page 53

Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Adjust the control cable.
f Air source control cable.
1. Slide the control lever to the left ("CIRC"
position).
2. Connect the control cable at the "CIRC" position
of the link unit of the blower assembly and
secure it with the clip.
f Temperature control cable.
1. Turn the control knob to the left ("MAX COLD"
position).
2. Connect the control cable at the "COLD"
position of the temperature control link of the
heater unit and secure it with the clip.
f Air select control cable
1. Turn the control knob to the right ("DEFROST"
position).
2. Connect the control cable at the "DEFROST"
position of the mode control link of the heater
unit and secure it with the clip.
2. Check the control cable operation.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–25
865RW005