Removal; Installation - Isuzu 1999 RODEO Workshop Manual

Removal

1. Remove rear wheels (1).
2. Remove 2 bolts to remove the caliper assembly (2)
from the support bracket. Refer to "Rear Disc Brakes"
in Power Assisted Brake System section. Temporarily
hang the caliper with wire etc.
3. Remove rotor (drum) (3).
4. Remove holding spring (4), upper return spring (5)
and lower return spring (6).
5. Previously remove the rear cable from the parking
brake lever, then remove the brake shoe assembly
(7).
Legend
(1) Parking Brake Lever
6. Remove cable fixing bolt (8) and bolt (9) (10) (11).
7. Remove nut (12).
8. Remove nut (13) and retainer (14).
9. Remove rear cable (15).

Installation

1. Apply grease (BESCO L–2 or equivalent) to the
connecting portion of the rear cable and equalizer.
Install rear cable (15).
2. Install retainer (14).
f Tighten nut (13) to the specified torque.
Torque: 41N·m (30lb ft)
3. Tighten nut (12) to the specified torque.
Torque: 15N·m (11lb ft)
4. Tighten bolt (11) (10) (9) to the specified torque.
Torque: 6.5N·m (57lb in)
f To adjust the parking brake, refer to "Parking Brake
Adjustment" in this section.
5. Tighten the cable fixing bolt (8) to the specified
Torque: 6.5N·m (57lb in)
PARKING BRAKE SYSTEM (4x4 Model)
6. Install shoe assembly (7).
After installation of the shoe and cable assembly,
apply special grease (included in the repair kit) to the
following portions indicated in the figure.
7. Install lower return spring (6) and upper return spring
(5).
The parking brake lever side (secondary side) return
spring must be installed on the outer side of the
primary side return spring.
308RW004
Legend
(1) Outer Side
(2) Parking Lever
8. Install holding spring (4).
9. Install rotor (drum) (3).
10. Install caliper assembly (2).
11. Install rear wheels (1).
5D1–5
308RS005
308RS003