Rear Propeller Shaft; Rear Propeller Shaft And Associated Parts 4C-39; Removal; Installation - Isuzu 1999 RODEO Workshop Manual

Rear Propeller Shaft and Associated Parts
Legend
(1) Bolt, Nut and Washer (Transfer Side)

Removal

1. Raise the vehicle on a hoist.
NOTE: Apply alignment marks on the flange at the rear
propeller shaft both front and rear side.
2. Remove transfer side bolt, nut and washer (except
spline yoke type).
3. Remove rear axle side bolt, nut and washer.
4. Remove rear propeller shaft.
NOTE: Plug the hole of the transmission rear end to
prevent oil leakage (spline yoke type only).

Rear Propeller Shaft

(2) Rear Propeller Shaft
(3) Bolt, Nut and Washer (Rear Axle Side)

Installation

NOTE: Never install the shaft assembly backwards.
Never insert bar between yoke lugs when tightening or re-
moving bolts.
Completely remove the dust or foreign matter from the
connecting surface of flange coupling on each end of the
propeller shaft.
1. Align the mark which is applied at removal.
2. Install rear propeller shaft and tighten the bolts to the
specified torque.
Torque: 63 N·m(46 lb ft)
DRIVE SHAFT SYSTEM
4C–39
401RX003