Main Data And Specifications - Isuzu 1999 RODEO Workshop Manual

4C–38
DRIVE SHAFT SYSTEM
1. Apply grease evenly to both the female and male
splines.
2. Apply a small amount of grease by finger to the outer
lips of the boot.
3. Slide the boot onto the yoke shaft being careful not to
damage the spline coating or boot.
4. Insert the yoke shaft spline into the sleeve being
careful to maintain proper phasing. The spider holes
should be in line and as per originally marked prior to
disassembly.

Main Data and Specifications

General Specifications
Transmission
Length (between two spiders
center)
Torque Specifications
5. Position boot onto sleeve and yoke shaft in final
position over boot grooves.
6. Attach boot clamps and secure using pliers.
7. Be sure clamp is properly seated and secure.
M/T
367.2 mm (14.81 in)
A/T
542.2 mm (21.35 in)
401RX001