Isuzu 1999 RODEO Workshop Manual page 309

4C–20
DRIVE SHAFT SYSTEM
7. Remove snap ring from front axle case by using snap
ring pliers.
8. Take out inner shaft from front axle case.
9. Remove snap ring from inner shaft by using snap ring
pliers.
10. Remove inner shaft bearing.
NOTE: Be careful not to damage the shaft.
412RW017
11. Remove needle bearing from inner shaft by using a
remover J–26941 and sliding hammer J–2619–01.
412RW016 12. Remove oil seal from front axle case.
NOTE: Be careful not to damage the front axle case.
412RW015
412RS045