Isuzu 1999 RODEO Workshop Manual page 301

4C–12
DRIVE SHAFT SYSTEM
9. Install lock washer and lock screw in the following
manner.
f Turn the side with larger diameter of the tapered
bore to the vehicle outer side, then attach the
washer.
f If the bolt holes in the lock plate are not aligned with
the corresponding holes in the nut, reverse the lock
plate.
f If the bolt holes are still out of alignment, turn in the
nut just enough to obtain alignment.
f Screw is to be fastened tightly so its head may
come lower than the surface of the washer.
10. Apply adhesive (LOCTITE 515 or equivalent) to both
joining flange faces then install hub flange.
11. Install snap ring and shim.
f Adjust the clearance between the free wheeling hub
body and the snap ring.
Clearance: 0 mm–0.3 mm (0 in–0.012 in)
Shims Available: 0.2 mm, 0.3 mm, 0.5 mm,
1.0 mm (0.008 in, 0.012 in, 0.020 in, 0.039 in)
12. Install hub cap.
13. Tighten the bolts to the specified torque.
Torque: 59 N·m (43 lb ft)
411RS012
411RW002