Isuzu 1999 RODEO Workshop Manual page 300

5. Apply grease (NLGI No.2 or equivalent) to the lip
portion, then install oil seal by using installer J–36830
and grip J–8092.
6. Install ABS sensor ring, then tighten the bolts to the
specified torque.
Torque: 18 N·m (13 lb ft)
7. Install hub and disc assembly.
f Apply grease in the hub.
f Apply wheel bearing type grease NLGI No. 2 or
equivalent to the outer and inner bearing.
Grease Amount
f Hub: 35 g (1.23 oz)
f Outer bearing: 10 g (0.35 oz)
f Inner bearing: 15 g (0.53 oz)
Legend
(1) Inner Bearing
(2) Hub
(3) Outer Bearing
8. Install hub nut.
Turn to the place where there is a chamfer in the
tapped hole to the outer side, then attach the nut by
using front hub nut wrench J–36827.
901RW057
Preload Adjustment
1. Tighten the hub nut to 29 N·m (22 lb ft), then fully
loosen the nut.
2. Tighten the hub nut to the value given below,
using a spring scale on the wheel pin.
New bearing and New oil seal
Bearing Preload: 20 N – 25 N (4.4 lb – 5.5 lb)
Used bearing and New oil seal
Bearing Preload: 12 N – 18 N (2.6 lb – 4.0 lb)
If the measured bearing preload is outside the
specifications, adjust it by loosening or tightening the
bearing nut.
411RS009
DRIVE SHAFT SYSTEM
4C–11
901RW054
411RS011