Isuzu 1999 RODEO Workshop Manual page 296

DRIVE SHAFT SYSTEM
4C–7
9. Install lock washer.
f Turn the side with larger diameter of the tapered
bore to the vehicle outer side, then attach the
washer.
If the bolt holes in the lock plate are not aligned with
the corresponding holes in the nut, reverse the lock
plate. If the bolt holes are still out of alignment, turn
in the nut just enough to obtain alignment. Screw is
to be fastened tightly so its head may come lower
than the surface of the washer.
411RS012
10. Install cover and tighten the cover bolt.
11. Install brake caliper and tighten fixing bolt.