Isuzu 1999 RODEO Workshop Manual page 295

4C–6
DRIVE SHAFT SYSTEM
5. Install inner bearing.
Install the outer race by driving it into the hub by using
installer J–36829 and grip J–8092.
6. Install oil seal by using installer J–36830 and grip
J–8092.
Apply Multipurpose grease NLGI No. 2 or equivalent
to the lip portion.
7. Apply Multipurpose grease NLGI No.2 in the hub and
bearing.
Hub
Outer bearing
Inner bearing
411RS023
901RW057
35 g (1.23 oz)
10 g (0.35 oz)
15 g (0.53 oz)
8. Install hub nut by using wrench J–36827.
Turn the place where there is a chamfer in the tapped
hole to the outer side, and attach the nut.
Preload Adjustment
1. Tighten the hub nut to 29.4 N·m (21.7 lb ft), then
loosen the nut to the full.
2. Tighten the hub nut to the value given below,
using a spring scale on the wheel pin.
Bearing Preload
New bearing and New
oil seal
Used bearing and New
oil seal
If the measured bearing preload is outside the
specifications, adjust it by loosening or tightening
the bearing nut.
901RW054
19.6 – 24.5 N
(4.4 – 5.5 lb)
11.8 – 17.7 N
(2.6 – 4.0 lb)
411RS011