Knuckle; Knuckle And Associated Parts; Removal - Isuzu 1999 RODEO Workshop Manual

3C–10 FRONT SUSPENSION

Knuckle and Associated Parts

Legend
(1) Torsion Bar
(2) Lower Ball Joint
(3) Back Plate
(4) Knuckle Assembly

(5) Knuckle

Removal

1. Raise the vehicle and support the frame with suitable
safety stands.
2. Remove wheel and tire assembly. Refer to Wheel in
this section.
3. Remove the brake caliper. Refer to Disc Brakes in
Brake section.
Knuckle
(6) Needle Bearing
(7) Thrust Washer
(8) Oil Seal
(9) Upper Ball Joint
(10) Wheel Speed Sensor
4. Remove the hub assembly. Refer to Front Hub and
Disk in this section.
5. Remove tie–rod end from the knuckle. Refer to Power
Steering Unit in Steering section.
6. Remove the speed sensor from the knuckle.
7. Loosen torsion bar by height control arm adjust bolt,
then remove torsion bar. Refer to Torsion Bar in this
section.
8. Remove wheel speed sensor.
410RW006