Knuckle And Associated Parts; Removal - Isuzu Trooper 1999 Workshop Manual

Knuckle and Associated Parts

Legend
(1) Torsion Bar
(2) Lower Ball Joint
(3) Back Plate
(4) Knuckle Assembly
(5) Knuckle

Removal

1. Raise the vehicle and support the frame with suitable
safety stands.
2. Remove wheel and tire assembly. Refer to Wheel
Replacement in this section.
3. Remove the brake caliper. Refer to Disc Brakes in
Brake section.
Knuckle
(6) Needle Bearing
(7) Thrust Washer
(8) Oil Seal
(9) Upper Ball Joint
(10) Wheel Speed Sensor
4. Remove the hub assembly. Refer to Front Hub and
Disk in Driveline/Axle section.
5. Remove outer track rod from the knuckle. Refer to
Outer Track Rod Assembly Replacement in Steering
section.
6. Remove the speed sensor from the knuckle.
7. Loosen torsion bar by height control arm adjust bolt,
then remove torsion bar. Refer to Torsion Bar
Replacement in this section.
FRONT SUSPENSION
3C 11
410RW001