Isuzu 1999 RODEO Workshop Manual page 147

11. Remove steering column cover.
12. Disconnect the wiring harness connectors located
under the steering column.
13. Remove the combination switch assembly with SRS
coil.
NOTE: SRS coil is a part of combination switch
assembly, which can not be replaced singly. Therefore,
be sure not to remove the SRS coil from the combination
switch assembly.
14. Remove snap ring.
15. Remove cushion rubber.
16. Remove shift lock cable (For A/T).
17. Disconnect the starter switch harness connector
located under the steering column, then remove lock
cylinder assembly.
POWER–ASSISTED STEERING SYSTEM
18. Apply a setting mark (1) across the universal joint and
second steering shaft to reassemble the parts in their
original position, then remove steering column
assembly and second shaft.
NOTE: A setting mark can be easily made if the shaft is
withdrawn a little by loosening the steering shaft universal
joint.
430RX005
825RW288
2A–45
431RW009