Steering; Power Steering; Steering Tips - Isuzu 2008 i290 Owner's Manual

TCS operates in all transmission shift lever positions.
But the system can upshift the transmission only as high
as the shift lever position you have chosen, so you
should use the lower gears only when necessary. See
Automatic Transmission Operation on page 2-21
and/or Manual Transmission Operation on page 2-23 for
more information.
If there is a problem with TCS, the warning light will
come on, and TRACTION FAULT will be displayed on
your Driver Information Center (DIC). When this warning
is displayed, the system will not limit wheel spin.
Adjust your driving accordingly.
To limit wheel spin, especially in slippery road
conditions, you should always leave TCS on. But you
can turn the system off if you ever need to. You should
turn the system off if your vehicle ever gets stuck in
sand, mud or snow and rocking the vehicle is required.
See Rocking Your Vehicle to Get It Out on page 4-30
and If Your Vehicle is Stuck in Sand, Mud, Ice, or Snow
on page 4-30 for more information.
Adding non-dealer/non-retailer accessories can affect
your vehicle's performance. See Accessories and
Modifications on page 5-3 for more information.
4-6

Steering

Power Steering

If you lose power steering assist because the engine
stops or the system is not functioning, you can steer but
it will take much more effort.

Steering Tips

It is important to take curves at a reasonable speed.
A lot of the "driver lost control" accidents mentioned on
the news happen on curves. Here is why:
Experienced driver or beginner, each of us is subject to
the same laws of physics when driving on curves.
The traction of the tires against the road surface makes
it possible for the vehicle to change its path when
you turn the front wheels. If there is no traction, inertia
will keep the vehicle going in the same direction. If
you have ever tried to steer a vehicle on wet ice, you
will understand this.
The traction you can get in a curve depends on the
condition of the tires and the road surface, the angle at
which the curve is banked, and your speed. While
you are in a curve, speed is the one factor you
can control.
2008 - Isuzu 290/370 Owner Manual