Mazda CX-7 2007 Workshop Manual page 1731

INSTRUMENT CLUSTER CONFIGURATION
Note
• The odometer data (total traveled distance) in the previous instrument cluster is automatically transferred
to a new instrument cluster during the configuration.
1. Connect the M-MDS to the DLC-2 (16-pin).
2. After set up the M-MDS (including the vehicle
recognition), the following can be selected from
the M-MDS screen.
Using an IDS (Notebook PC):
• "Module Programming"
Using a PDS (Pocket PC):
• "Programming", "Module Programming"
3. Select "Programmable Module Installation".
4. Select "HEC" and perform procedures according
to directions on the M-MDS screen.
5. Retrieve DTCs using the M-MDS and verify that
there is no DTC present.
• If any DTC is present, perform applicable
DTC inspection. (See 09-02E-1 DTC TABLE[INSTRUMENT CLUSTER].)
End Of Sie
INSTRUMENT CLUSTER DISASSEMBLY/ASSEMBLY
Caution
• Do not drop the instrument cluster or damage the printed board. This will lead to a system
malfunction.
1. Disassemble in the order indicated in the table.
1 Screw
2 Cover
3 Lens
4 Instrument cluster unit
2. Assemble in the reverse order of disassembly.
End Of Sie
INSTRUMENT CLUSTER INSPECTION
Speedometer
Using the input/output check mode
1. Inspect the speedometer by setting it to check code 12 of the input/output check mode. (See 09-22-5
INSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODE.)
Using a speedometer tester
1. Adjust the tire pressure to the specification.
2. Using a speedometer tester, verify that the tester reading is as indicated in the table below.
Speedometer tester
indication (km/h)
20
40
60
80
100
120
140
INSTRUMENTATION/DRIVER INFO.
Allowable range (km/h)
18— 22
38— 41
58— 62
78— 82
97— 102
117— 122
136— 142
DLC-2
5
4
id092200800300
acxuuw00001906
id092200801600
09-22
3
2
1
acxuuw00001907
id092200800400
09-22–3