Mazda 6 2002 Workshop Manual page 991

4. Stack the tire with the pre-tensioner seat belt on
top of two tires. Stack a tire on top of the three
tires. Stack another tire that has a wheel on top of
the four tires.
5. Tie all tires together with wire.
6. Connect the SST (Deployment tool) to the SST
(Adapter harness).
7. Connect the red clip of the SST (Deployment tool)
to the positive battery terminal and the black clip
to the negative battery terminal.
8. Verify that the red light on the SST (Deployment
tool) is illuminated.
9. Make sure all persons are standing at least 6 m
{20 ft} from the vehicle.
10. Press the activation switch on the SST
(Deployment tool) to deploy the pre-tensioner
seat belt.
End Of Sie
AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DISPOSAL PROCEDURES
Warning
• • • • Before scrapping a vehicle with a live (undeployed) air bag module and pre-tensioner seat belt,
deploy the air bag module and pre-tensioner seat belt. Never dispose of a live (undeployed) air
bag module and pre-tensioner seat belt.
• • • • The air bag module and the pre-tensioner seat belt are very hot immediately after they are
deployed. You can get burned. Do not touch the air bag module and pre-tensioner seat belt for at
least 15 minutes after deployment.
• • • • Pouring water on the deployed air bag module and pre-tensioner seat belt is dangerous. The water
will mi with the residual gases to form a gas that can make breathing difficult. Do not pour water
on the deployed air bag module and pre-tensioner seat belt.
AIR BAG SYSTEM
A6E8130W039
A6E8130W034
T
A6E8130W054
A6E8130W028
A6E813057000W02
T–139