Mazda 6 2002 Workshop Manual page 1111

Outlet Pipe Assembly Note
1. Wrap the insulator around the outlet pipe as
shown in the figure.
End Of Sie
EXPANSION VALVE REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See
Caution
• • • • If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and
abnormal noise will occur. Always immediately plug open fittings after removing any refrigeration
cycle parts to keep moisture or foreign material out of the cycle.
3. Disconnect the cooler hose (Lo) (L.H.D) or cooler pipe No.4 (R.H.D.) and cooler pipe No.3. (See
REFRIGERANT LINES
4. Remove the dashboard. (See
5. Remove the duct (1).
6. Remove the air mi actuator. (Full-auto air conditioner)
7. Remove the screws and cover.
8. Remove the one plate (L.H.D.) or two plates (R.H.D.).
9. Remove the bolts and shift the outlet pipe. Do not allow compressor oil to spill.
BASIC SYSTEM
U–9
REMOVAL/INSTALLATION.)
S–82 DASHBOARD
RECOVERY.) (See U–9
REMOVAL/INSTALLATION.)
A6E8516W028
A6E8516W031
A6E851661130W03
CHARGING.)
U–25
U–21
U