AIR FILTER REMOVAL/INSTALLATION
1. Remove the glove compartment.
2. Remove in the order indicated in the table.
1
Air filter cover
2
Air filter
3. Install in the reverse order of removal.
End Of Sie
AIR FILTER INSPECTION
1. Remove the air filter.
2. Inspect the air filter.
• If the air filter is damaged, ecessively dirty, or foul smelling, replace the air filter.
Note
• The air filter cannot be reused by cleaning it with water or compressed air.
• Replace the air filter at the following interval, depending on operating conditions.
Destinations
Type
Europe (L.H.D.
Aldehyde, pollen,
U.K.) specs.
and a dust removal
Pollen, and a dust
removal
GCC specs.
End Of Sie
A/C UNIT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See
3. Drain the engine coolant. (See
4. Remove the dashboard. (See
5. Remove the theft-deterrent control module. (See
REMOVAL/INSTALLATION.)
Caution
• • • • If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and
abnormal noise will occur. Always immediately plug open fittings after removing any refrigeration
cycle parts to keep moisture or foreign material out of the cycle.
BASIC SYSTEM
Interval (year or
km {miles})
1 or 20,000
{12,500}
2 or 40,000
{25,000}
1 or 20,000
{12,500}
U9
RECOVERY.) (See
E3 ENGINE COOLANT
S82 DASHBOARD
REMOVAL/INSTALLATION.)
T86 THEFT-DETERRENT CONTROL MODULE
U9
CHARGING.)
REPLACEMENT.)
A6E851661140W03
A6E8516W018
A6E851661140W04
U
A6E851661130W01
U15