ON-BOARD DIAGNOSTIC [CRUISE CONTROL SYSTEM]
ON-BOARD DIAGNOSTIC [CRUISE CONTROL SYSTEM]
FOREWORD
Outline
• There are two on-board diagnostic functions: Operation mode, which inspects for and indicates correct
operation of the input signals to the control module, and condition detection mode, which indicates troubles in
the system.
• The two functions can be done using either of the following methods:
Verifying the flashing pattern of the cruise set indicator light in the instrument cluster.
Inspection Order
End Of Sie
INSPECTION OF DTCS FOR OPERATION MODE
Note
• The cruise set indicator light will illuminate for 3 seconds when operation mode is on.
• If the cruise set indicator light does not illuminate for 3 seconds (Operation mode is not on) the following
may be the cause of the malfunction:
Cruise actuator ignition power supply fuse
Cruise set indicator light power supply fuse
Cruise control switch
Cruise control main switch
Clock spring for air bag system
Print plate in instrument cluster
Cruise set indicator light bulb
Cruise actuator
Open or short circuit in following wiring harnesses:
• Between cruise set indicator light and cruise actuator terminal G
• Between fuse block and cruise actuator terminal L
• Between fuse block and instrument cluster
• Between cruise actuator and clock spring
• Between clock spring and cruise control switch
Open circuit in following wiring harnesses:
• Between cruise actuator terminal I and ground
• Between clock spring and ground
1. Turn the ignition switch to the ON position.
2. Verify that the cruise control main switch is off.
A6E817266350W01
T
A6E8172W001
A6E817266350W02
T179