Fig. 4: Installing Wheel Hub Bolt By Placing Proper Sized Washer On Hub & Tightening Nut
Courtesy of MAZDA MOTORS CORP.
WHEEL HUB, STEERING KNUCKLE REMOVAL/INSTALLATION
CAUTION:
1. Remove in the order indicated in Fig. 5 .
2. Install in the reverse order of removal.
3. After installation, inspect front wheel alignment. (See FRONT WHEEL ALIGNMENT .)
2007 Mazda MX-5 Miata Sport
2007 DRIVELINE/AXLES Front Axle - MX-5 Miata
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the wiring
harness if it is pulled by mistake. Before performing the following
procedures, disconnect the ABS wheel-speed sensor harness
connector (axle side) and fix it to an appropriate place where the
sensor will not be pulled by mistake while servicing the vehicle.