Reboot - Extreme Networks ExtremeWare Command Reference Manual

Commands for Accessing the Switch

reboot

reboot {time <date> <time> | cancel} {slot <slot number> | msm-a | msm-b}
Description
Reboots the switch or the module in the specified slot at a specified date and time.
Syntax Description
date
time
cancel
slot number
msm-a
msm-b
Default
N/A.
Usage Guidelines
If you do not specify a reboot time, the switch will reboot immediately following the command, and
any previously scheduled reboots are cancelled. To cancel a previously scheduled reboot, use the
option.
cancel
The
slot <slot number>
specific slot. When you specify this option, the command applies to the module in the specified slot,
rather than to the switch. In general, the modules that can be rebooted have separate images from the
ExtremeWare image for the switch.
The modules that can be rebooted are: E1, T1, T3, ARM, ATM, MPLS, PoS, and slave or switch fabric
MSM modules.
NOTE
When you configure a timed reboot of an MSM, there is no show output in the CLI to view the
configuration.
The E1, T1, and T3
reboot slot
command can only be executed immediately.
Example
The following command reboots the switch at 8:00 AM on April 15, 2002:
reboot 04/15/2002 08:00:00
The following command reboots the MPLS module in slot number 5:
94
Specifies a reboot date in mm/dd/yyyy format.
Specifies a reboot time in hh:mm:ss format.
Cancels a previously scheduled reboot.
Specifies the slot where the module is installed.
Specifies a BlackDiamond MSM module installed in slot A.
Specifies a BlackDiamond MSM module installed in slot B.
option is added to the command to make it possible to reboot a module in a
command does not support the or keywords, so this
time cancel
ExtremeWare Software 7.3.0 Command Reference Guide