Extreme Networks ExtremeWare Command Reference Manual page 846

Security Commands
NOTE
You can configure multiple DHCP address ranges for a VLAN. The start-addr option in the command
(50.0.0.5 in this example) specifies the exact DHCP address range for which the command applies. If
the last option is not specified, the command is applied for the primary subnet.
History
This command was first available in ExtremeWare 6.2.
This command was modified so that remote or secondary subnets could be configured for DHCP
options in ExtremeWare (through the addition of the parameter ). This enhanced command
start-addr
was made available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
846 ExtremeWare Software 7.3.0 Command Reference Guide