unconfigure vlan dhcp-options
NOTE
You can configure multiple DHCP address ranges for a VLAN. The start-addr option in the command
(50.0.0.5 in this example) specifies the exact DHCP address range for which the command applies. If
the last option is not specified, the command is applied for the primary subnet.
History
This command has been modified so that clearing the DHCP options for secondary or remote subnets is
possible (through the addition of the parameter
). This enhanced command was made
start-addr
available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
967