Reboot - Extreme Networks ExtremeWare Command Reference Manual

reboot

For the "i" series switches:
reboot {time <date> <time> | cancel} {slot <slot number> | msm-a | msm-b}
For the "e" series switches:
reboot {time <date> <time> | cancel}{slot <slot number>}
Description
Reboots the switch or the module in the specified slot at a specified date and time.
Syntax Description
date
time
cancel
slot number
msm-a
msm-b
Default
N/A
Usage Guidelines
If you do not specify a reboot time, the switch will reboot immediately following the command, and
any previously scheduled reboots are cancelled. To cancel a previously scheduled reboot, use the
option.
cancel
On the "i" Series of Switches. The
possible to reboot a module in a specific slot. When you specify this option, the command applies to the
module in the specified slot, rather than to the switch. In general, the modules that can be rebooted
have separate images from the ExtremeWare image for the switch.
The modules that can be rebooted are: E1, T1, T3, ARM, ATM, MPLS, PoS, and slave or switch fabric
MSM modules.
NOTE
When you configure a timed reboot of an MSM, there is no show output in the CLI to view the
configuration.
ExtremeWare 7.5 Command Reference Guide
Specifies a reboot date in mm/dd/yyyy format.
Specifies a reboot time in hh:mm:ss format.
Cancels a previously scheduled reboot.
Specifies the slot where the module is installed on the "i" series of switches.
Specifies the switch ID in a stack of switches on the "e" series of switches.
Specifies a BlackDiamond MSM module installed in slot A.
NOTE: This feature is only available only on BlackDiamond.
Specifies a BlackDiamond MSM module installed in slot B.
NOTE: This feature is only available only on BlackDiamond.
slot <slot number>
option is added to the command to make it
reboot
107