Extreme Networks ExtremeWare Command Reference Manual page 626

Hide thumbs Also See for ExtremeWare:

Table of Contents

Commands for Status Monitoring and Statistics

By default, all log targets are associated with the built-in filter, DefaultFilter. Therefore, the most

straightforward way to send additional messages to a log target is to modify DefaultFilter. In the

following example, the command modifies the built-in filter to allow incidents in the STP component,

and all subcomponents of STP, of severity critical, error, warning, notice and info. For any of these

events containing a physical port number as a match parameter, limit the incidents to only those

occurring on physical ports 3, 4 and 5 on slot 1, and all ports on slot 2:

configure log DefaultFilter add events stp severity info match ports 1:3-1:5, 2:*

If desired, issue the

command to restore the DefaultFilter back to its

unconfigure log DefaultFilter

original configuration.

This command was first available in ExtremeWare 7.1.0.

Platform Availability

This command is available on all platforms.

ExtremeWare Software 7.3.0 Command Reference Guide

Extremeware 7.3.0