Configure Snmpv3 Target-Addr-Ext - Extreme Networks ExtremeWare Command Reference Manual

Commands for Managing the Switch

configure snmpv3 target-addr-ext

configure snmpv3 target-addr-ext {hex} <addr name> mode [standard |
enhanced] {ignore-mp-model} {ignore-event-community}
Description
Configure an entry in the extremeTargetAddrExtTable.
Syntax Description
hex
addr name
enhanced
standard
ignore-mp-model
ignore-event-community
Default
The default values are:
• mode—enhanced
• ignore-mp-model—False, the mp-model is not ignored.
• ignore-event-community—False, the EventCommunity is not ignored.
Usage Guidelines
The command
snmp add trapreceiver
ExtremeWare. This command allows you to set trap receivers without using the details of SNMPv3.
However, when the command is executed, it internally sets a per-trap-receiver flag called
ignore-mp-model, and ignore-event-community. This command is never uploaded to the switch, but its
equivalent SNMPv3 command,
has no tokens for ignore-mp-model or ignore-event-come. Therefore, upon downloading the configuration,
the setting for these objects is lost.
This separate command corresponds to a private SNMP table that was subsequently added. The table
contains three objects, ignoreMPModel, useEventCommunity, and Mode. This private table, the
extremeTargetAddrExtTable, is an extension to the standard snmpv3TargetAddrTable
Example
The following command that standard traps will be used:
configure snmpv3 target-addr-ext A1 mode standard
History
This command was first available in ExtremeWare 7.1.0.
156
Specifies that the value to follow is to be supplied as a colon separated string
of hex octets.
Specifies a string identifier for the target address.
Specifies enhanced traps, which contain extra varbinds at the end.
Specifies standard traps, which do not contrain the extra varbinds.
Sets the ignore message passing model flag
Sets the use Event Community flag to false.
was retained when SNMPv3 support was added to
configure snmpv3 add target-addr
, is uploaded instead. The latter
ExtremeWare Software 7.3.0 Command Reference Guide