Extreme Networks ExtremeWare Command Reference Manual page 291

Hide thumbs Also See for ExtremeWare:

Table of Contents

— QoS profiles

If you do not specify a port number or range of ports, detailed system-related information is displayed

for all ports. The data is displayed in a table format.

On a modular switch,

can be one or more port numbers. For a detailed explanation of port specification, see "Modular Switch

Numerical Ranges" or "Stand-alone Switch Numerical Ranges" in Chapter 1.

This status information may be useful for your technical support representative if you have a network

For version 6.0 and later:

with written explanations versus displayed in a table format.

For version 6.2.2 and later:

• The detailed output displays a link filter counter. The link filter counter is calculated at the middle

layer on receiving an event. The link filter up indicates the number of link transitions from down to

up at the middle layer filter. The link filter down indicates the number of link transitions from up to

down at the middle layer filter.

If you telnet to the switch and use the show ports info detail command, the line feeds might not be

recognized, resulting in output lines overwriting previous lines.

The following command displays port system-related information:

show ports info

Following is sample output from this command:

ExtremeWare Software 7.3.0 Command Reference Guide

can be a list of slots and ports. On a stand-alone switch,

parameter is used to provided more specific port information. The data is called out

P e--m-------D ready

P e--m-------E ready

P e--m-------D ready

P e--m-------E ready

Link Num Num

STP VLAN Proto Size

show ports info

Profile Mast

Extremeware 7.3.0