Show Vlan - Extreme Networks ExtremeWare Command Reference Manual

VLAN Commands

show vlan

show vlan {<vlan name> | detail | stats {vlan} <vlan-name>}
Description
Displays configuration information about specified VLANs.
Syntax Description
vlan-name
detail
stats
Default
Summary information for all VLANs on the device.
Usage Guidelines
Unlike many other vlan-related commands, the keyword "vlan" is required in all forms of this
command except when requesting information for a specific vlan.
Use the command
show vlan
configuration options as a series of "flags" (see the example below). VLAN and protocol names may be
abbreviated in this display.
Use the command
show vlan detail
same information as for an individual VLAN, but shows every VLAN, one-by-one. After each VLAN
display you can elect to continue or quit.
Protocol None indicates that this VLAN was configured with a user-defined protocol that has
subsequently been deleted.
Use the command
show vlan stats <vlan name>
packets transmitted and received for the named VLAN. This command will continue to run until you
cancel it using the [Esc] key.
Using the option of his command displays secondary IP addresses, which are displayed in the
detail
line following the primary IP address output.
348
Specifies the name of the VLAN whose configuration is to be displayed.
Specifies that detailed information should be displayed for each VLAN.
Specifies a real-time display of utilization statistics (packets transmitted and
received) for a specific VLAN.
to display summary information for all VLANs. It shows various
to display detailed information for all VLANs. This displays the
to show real-time statistics on the number of
ExtremeWare Software 7.3.0 Command Reference Guide