Extreme Networks ExtremeWare Command Reference Manual page 632

Commands for Status Monitoring and Statistics
Table 14: Default Target Log Characteristics
Target Enabled Severity Level Pre-7.1.0 Command to Set Log Severity
console display no info
memory buffer yes debug-data
NVRAM yes warning
session no info
syslog no debug-data
The built-in filter, DefaultFilter, and a severity level of
values may be overridden on a per-session basis using the
and specify the target as
changes:
configure log target session filter <filter name> {severity <severity> {only}}
Configuration changes to the current session target are in effect only for the duration of the session, and
are not saved in FLASH memory. The
changes are desired to be temporary. If changes to the console-display are to be permanent (saved to
FLASH memory), use the following form of the command:
configure log target console-display filter <filter name> {severity <severity> {only}}
In versions prior to ExtremeWare 7.1.0, so-called
above were stored in NVRAM so they would be available across a reboot. This remains the default
behavior for ExtremeWare releases, but message filtering for the NVRAM target is now configurable.
Example
The following command sends log messages to the previously syslog host at 10.31.8.25, port 8993, and
facility , that pass the filter myFilter and are of severity
local3
configure log target syslog 10.31.8.25:8993 local3 filter myFilter severity warning
The following command sends log messages to the current session, that pass the filter myFilter and are
of severity and above:
warning
configure log target session filter myFilter severity warning
History
This command was first available in ExtremeWare 7.1.0
Platform Availability
This command is available on all platforms.
632
configure log display {<severity>}
N/A
N/A
N/A
configure syslog add <host name/ip> {: <udp-port>}
[local0 ... local7] <severity>
. Use the following form of the command for per-session configuration
session
option can also be used on the console display, if the
session
static
are used for each new telnet session. These
info
configure log target filter
messages with a severity level of
and above:
warning
ExtremeWare Software 7.3.0 Command Reference Guide
command
and
warning